9
ASSEMBLY (cont.)
6. To fit the feed wheel handles (6),
screw them into the feed wheel hub
(5) (Fig. 6 & 7).
7. To fit the 13mm keyed chuck (18), first place a piece of
timber on the table (11) and position the 13mm keyed
chuck (18) with the jaws retracted under the drive shaft.
Raise the table (11) toward the drive shaft until the 13mm
keyed chuck (18) is approximately 25mm from the drive
shaft (Fig. 8).
8. To secure the 13mm keyed chuck (18) to the drive shaft
gently lower the drive shaft using the feed wheel handles
(6) (Fig. 9) until the drive shaft is pushed into the hole of
the 13mm keyed chuck (18). A gentle tap on the timber is
required to secure the 13mm keyed chuck (18) onto the
tapered drive shaft.
Fig. 8
Fig. 9
Fig. 6
Fig. 7
Summary of Contents for DP-350
Page 1: ......
