page.
24
/
42
24
MAINTENANCE AND THE LUBRICATION OF THE MACHINE
6.
MAINTENANCE AND THE LUBRICATION OF THE MACHINE
1.
All air and electrical energy should be disconnected before maintenance.
2.
In order to disconnect the electric energy, set the power switch ‘’OFF’’ position.
3.
In order to disconnect the air completely, separate the air input hose from the machine.
4.
Perform the cleaning of the machine every day. Clean the daily sawdust. The cleaning can be
performed with an air gun.
5.
Use only the lubrication products recommended by our factory.
6.
Add oil by checking the filter-regulator for its oil level.
7.
Electrical and pneumatic panels should be cleaned once a month with air against the dust
and sawdust.
8.
The dismantling and assembling process of the motor cutter ends should be performed by an
expert.
9.
If the clamping cylinders do not press the profile, the pressure should be checked from the
air lubricator.
10.
The machine needs at least 6 bar air pressure. Pressure should be followed.
Daily maintenance
►
Clean machine and surround area with compressed area.
►
Clean with duster oil, shaves, dust etc.
►
Check bladesaw. Must be changed if blunt or saw damage occurs. See page 25 CHANGING THE
►
Check condensate level in filter-regulator. See page 30 FILTER-REGULATOR.
Weekly maintenance
►
Check oil level in filter-regulator. See page 30 FILTER-REGULATOR.
►
Check oil feeding. See page 30 FILTER-REGULATOR.
Monthly maintenance
►
Check weekly maintenance
6.1
MAINTENANCE TABLE
Daily
Weekly
Monthly
Clean machine and
area from dust, oil etc.
X
Check the sawblade
X
Check the oil level in
filter-regulator
X
Check the oil feeding
in filter-regulator
X
Check the condensate
level in filter-regulator
X
