page.
21
/
42
21
PRINCIPLES OF WORK
5.7
LONG PROFILE CUTTING over 4000 mm
LONG SIZE CUTTING
START
STOP
TO END
TARG. SIZE
5000 mm
SIZE
1500 mm
90
°
90
°
LEFT SAW
RIGHT SAW
03 sec.
03 sec.
Picture 5.7-1 Long profile cutting mode
1.
Target size. Cutting size value.
2.
Size. Actual position size value.
3.
Time interval for saw output - Head №1.
4.
Time interval for saw output - Head №2.
5.
Angle position for Head №1.
6.
Angle position for Head №2.
7.
“Start”. Cutting start command.
8.
“Stop”. Cutting stop command.
9.
“To End” Program Start command
10.
Arrow “Back”. To enter main menu.
WORKING PRINCIPLE
►
The principle of given operation mode consists in automatic cutting of profile which length over
4000 mm. Basically it is used for aluminium profiles cutting.
1.
Enter the size you will finally obtain (1).
2.
Enter time intervals for saw output (3) & (4).
Time intervals could be changed depends on saw output speed, width of cutting material
(profile).
3.
Enter angle position for both heads (5) & (6). Heads automatically set on 45° or 90°.
4.
Push “To End”. Head №2 will go the last point on machine.
5.
Put profile for cutting on plate of machine.
6.
Open motors on both heads (5) and (9).
7.
Push “Start” (7). Automatic program starts:
Pneumatic cylinders clamp profile. Head №1 makes cutting, after that pneumatic cylinder on
Head №1 pulls out and Head №2 starts to slide profile to the left on the necessary size.
Pneumatic cylinders on Head №1 clamp, on Head №2 pull out and Head №2 will move on
necessary size, after that pneumatic cylinders on Head №2 will clamp and cuttion operation
on Head №2 will be performed. After that all pneumatic cylinders will pull out. Operation is
finished.
1
2
3
4
6
5
8
7
9
10
