page.
23
/
42
23
PRINCIPLES OF WORK
Pneumatic cylinder of Head №1 pulls out, Head №2 slides profile to the left side for required
size (4).
Pneumatic cylinder of Head №1 clamps and left side cutting happens at the same time
pneumatic cylinder of Head №2 pulls out and Head №2 moves left side for required size.
While Head №2 is cutting, pneumatic cylinder of Head №1 pulls out and Head №2 moves
left and slides profile for required size.
Operation is repeating till profile obtains minimum cutting size.
5.9
INTERMEDIATE DEGREE SETTING
1.
Left head fixation handle.
2.
Мechanic valve for left
head.
3.
Мechanic valve for right
head.
Picture 5.9-1 Intermediate degree setting
►
Intermediate angle degree setting between 45° & 90° performs in following way
1.
Release the air pressure by switching OFF valves on left head front part.
2.
Slack fastening of the head - turn the fixation handle counter-clockwise.
3.
Arrange heads on required degree.
4.
Fix the fastening.
Automatic angle degree setting.
To start automatic angle degree setting you should slack fastening of the head and switch
ON valves (2) and (3).
1
2
3
