FOR ASSISTANCE CALL 1-800-275-6187
7.2
RMX™ operators are available for use in jackshaft or trolley configurations.
The same control board is used for either configuration, however the con-
trol board must be set for the appropriate GDO configuration. A board set
for trolley mode will not work in a jackshaft operator and vice-versa.
NOTE
: The GDO type is factory set. The installer should not have to set
this feature. However, if the GDO type is inadvertently changed, or if a
board needs to be replaced in the field, follow these instructions to set
GDO type.
1) Press CAL/RUN to enter calibration mode.
2) Press SCROLL (DN) or (UP) until display reads “GDO TYPE
>
.”
This will display the current GDO type.
3) Press SET/CLEAR until display indicates correct GDO type
( J-SHAFT or TROLLEY)
4) Press CAL/RUN to return to run mode.
Operator Type
Fig. 3
GDO TYPE J-SHAFT
Figure 3
07/30/09
