![background image](http://html1.mh-extra.com/html/oventrop/datalog-cs-bs-1/datalog-cs-bs-1_installation-and-operating-instructions-for-the-specialised-installer_1662720023.webp)
en
Installation
Data expor
t /
configuration
Eliminating er
rors
Configuration
W
eb interface
23
Indications
3.4
LAN connection
The Datalog CS-BS-1 can be connected to a router by using a network cable
(CAT5e, RJ45).
Î
Connect the network cable included to the network adapter of the router and
to the LAN connector of the Datalog CS-BS-1.
For the next step of commissioning, see chapter 6 Basic configuration on page 10.
The integrated LAN connector
is located on the right-hand side of the device.
The LAN connector supports transfer rates of up to 100 MBit per second.
4
Indication and operating element
The following elements are featured on / in the housing of the Datalog CS-BS-1:
1 operating control LED / reset button
2 LAN connector
4.1
Operating control LED
The operating control LED
indicates the operating status of the Datalog CS-
BS-1 by issuing flashing signals and colours.
4.2
Reset button
The reset button
is integrated in the operating control LED. By means of the
reset button, the configuration of the Datalog CS-BS-1 can be reset to the factory
settings.
LED flashing codes
Colour
Permanent
Flashing
Fast flashing
Orange
S-Bus
signal available, no con-
nection to Oventrop Portal
No S-Bus signal available
Reset is running
Green
S-Bus signal and connection
to Oventrop Portal available
S-Bus signal and IP address
available, no connection to
Oventrop Portal
Orange /
Green
The device is
booting
LED off
The device is booting.
No mains voltage available.