oventrop Datalog CS-BS-1, Installation And Operating Instructions For The Specialised Installer

Page: 30 / 80

en
Installation
Configuration
Data expor
t / configuration
W
eb interface
Eliminating er
rors
30
Indications
the Datalog CS-BS-1 Communication module is not found by the DeviceDiscoverytool
Problem Solution
The Datalog CS-BS-1 is not found by the DeviceDiscovery-
Tool. Check the following points in order to find and eliminate the error.
Î Check if the power supply to the Datalog CS-BS-1 is established.
Î Check if the network cable is properly connected at both ends!
Î Check if the firewall software of the computer inhibits the connection to the Datalog CS-BS-1.
Î Switch off the firewall software and use the DeviceDiscoveryTool to find the Datalog CS-BS-1.
Î When the Datalog CS-BS-1 has been found, the firewall software has to be reconfigured.
Î Activate the firewall software!
Î Check if an IP address is assigned to the Datalog CS-BS-1.
An IP address has to be assigned to the Datalog CS-BS-1 by a router or a directly connected PC. This
process may take several minutes.
Computers with a Windows operating system indicate an IP assignment in progress by displaying a
symbol on the task bar. The symbol consists of two computers orbited by a yellow ball.
Î Check if an IP address is automatically assigned to the computer upon a direct connection to the
Datalog CS-BS-1.
In order to check the automatic IP address retrieval, proceed as follows:
Î Click the Start symbol on the task bar.
Î
In the Settings menu, select the Control panel.
Î Double-click Network connections .
Î
Right-click the Datalog CS-BS-1 connection.
Î Click Properties .
Î Mark tCP/IP Internet protocol .
Î Click the Properties button.
Î Mark the Obtain IP address automatically field.
Î Mark the Obtain DNS server address automatically field.
Î Close all windows by clicking OK .
Î Check if the proxy server settings for the operating system are correct.