en
Installation
Data expor
t /
configuration
Eliminating er
rors
Configuration
W
eb interface
27
Indications
6.4
Changing the password
In order to change the password, proceed as follows:
Î
In the main menu
Device config
, select the sub-menu
Users
.
The
Change password
tab opens.
Î
Tick the
Change password
checkbox.
Î
Enter the current password into the
Current p
a
ssword
input field.
The factory setting for the password is
admin.
Î
Enter the new password into the
New password
input field.
Î
Enter the new password into the
Repeat new password
input field.
Î
Click
Save configuration
.
The message
Configuration saved successfully!
appears.
6.5
Changing the device name
Note
Choose a descriptive device name to facilitate identifying the Datalog CS-
BS-1 in the network.
In order to change the device name, proceed as follows:
Î
In the main menu
Device Config
, select the sub-menu
General
.
Î
On the
General Configuration
tab, enter the device name in the
Device
Name
input field.
Permitted characters are: letters, numbers, underscores.
Special characters are not allowed.
Î
In the
Default Language
dropdown menu, select the desired language.
Î
Click
Save configuration
.
The message
Configuration saved successfully!
appears.
6.6
Configuring automatic firmware update settings
The firmware is the internal software of the Datalog CS-BS-1. Through firmware
updates, the software will be improved in the following ways:
• Extended functional range
• Enhanced operation
• Customisation of the web interface desktop
When automatic firmware updates are enabled (strongly recommended), the Data-
log CS-BS-1 will search for new firmware versions in regular intervals.
Note
Previous configurations are not affected by a firmware update.
6.7
Configuring the remote access
AttENtION!
third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î
Do change the remote access password, note it down
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
Datalog CS-BS-1 is to be accessed via the ServiceCenter software.
In order to change the remote access password, proceed as follows:
Î
In the main menu
Device Config
, select the sub-menu
Remote Access
.
Î
On the
Access S-Bus over local network
tab, tick the
Change password
checkbox.
Î
Enter the current password into the
Current password
input field.
The factory setting for the remote access password is
sbus.
Î
Enter the new password into the
New password
input field.
Î
Enter the new password into the
Repeat new password
input field.
Î
Click
Save configuration
.
The message
Configuration saved successfully!
appears.