B-320-2-E
20
7. RECONFIGURATION
In most cases, the pushbuttons arranged on the register front cover do the job (Sec. 7.1). When the register
front cover is removed for parameter changes or inspection, work with internal pushbuttons shown in Sec. 6.3
"Register Internal Assembly".
7.1 Establishing a Batch Setpoint
To establish a new batch setpoint, reset, while the LCD shows the batch setpoint, the current setpoint and hold
STOP
ROT.
button depressed for more than 3 seconds. The LCD (batch setpoint) will then begin to blink, indicating
that a new setpoint is acceptable.
Conditions unacceptable for changing batch setpoints
(1) SW1-2 is in the ON (SET).
(2) Cumulative total count is displayed.
(3) Missing pulses have been detected to activate an alarm.
(4) An overshoot has been detected to activate an alarm.
(5) A batch end output is present.
(6) A batch process is in progress.
CAUTION:
1. If an alarm output is present, reset it before changing setpoints.
2. While the register is simply adding up counts of incoming flow signal, other than in a
batch process, then changing batch setpoints presents no problem.
7.1.1 Procedure (batch setup mode)
On seeing the LCD (batch setpoint) blinking in response to the operation above, you can change the current
setpoint by the following procedure.
6 digits
BATCH SETUP MODE
LCD (batch setpoint display) blinks.
To RUN Mode
Batch setpoint is illuminated for 2 sec. approx.
NOTE
or
Adjust Figure
Carry
Batch
Setpoint
Set
YES
NO
: To exit from setup mode without changing setpoint.
CHG
In the add counter, following the setup procedure above, the display shows the new
setpoint for 2 sec. approx. and goes back automatically to show "0" (RUN mode).
Set a figure with two
pushbuttons.
START
▲
RESET
▲
STOP
ROT.
STOP
ROT.
Upon depression of
STOP
ROT.
button, the figure is stored and the LCD display returns to the RUN mode.
In the batch setup mode, absence of any command with button depressions for more than 10 seconds approx.
causes the LCD to return to the previous setting, bringing back RUN mode automatically.
