B-320-2-E
2
7.1.2 Example of Establishing a Batch Setpoint
●
Shown below is the procedure to set up a batch at 123456 (in the add counter).
Following resetting the current batch setpoint, hold button depressed for more than 3 seconds.
Press once.
Press once.
Press twice.
Press once.
Press thrice.
Press once.
Press once.
At touch of the figure is stored in the memory and the LCD display returns to the normal batch display.
If you have taken figure place
up more than necessary,
If you have taken figure place
up more than necessary,
Batch Setup Mode
LCD (batch setpoint) blinks.
Previous setpoint blinks.
LCD display: 123
→
1230
LCD display: 120
→
123
LCD display: 12
→
120
LCD display: 10
→
12
LCD display: 0
→
10
LCD display: 0
→
1
Set up from the most
significant digit:
"1" in this example.
Adjust the figure until the LCD displays "123456" and
press to end the setup procedure.
Similarly, keep on adjusting the figure at the rightmost of the LCD with
and taking the figure place up with .
Press the button a number
of times to adjust the figure.
Press the button a number
of times to adjust the figure.
If you have taken the figure place up more than necessary, like
１→
10
→
100, press button a number of times until the
LCD display shows 0 and go back to
→
to start all over again.
If the figure has gone too far,
→
0
→
1
→
2 …
→
9
Press the button a number of
times to adjust the figure.
In the operations below, absence of any key entry for
more than 10 seconds will cause the LCD to return to
the previous setting and to the RUN mode automatically.
To change batch setpoints, we recommend to press
a number of times until the LCD display shows 0 and
then set up as outlined below.
START
▲
START
▲
START
▲
START
▲
RESET
▲
RESET
▲
RESET
▲
RESET
▲
RESET
▲
RESET
▲
STOP
ROT.
STOP
ROT.
STOP
ROT.
STOP
ROT.
If the figure has gone too far,
→
0
→
1
→
2 …
→
9
If the figure has gone too far,
→
0
→
1
→
2 …
→
9
