22.
When all walls are attached
together, check alignment with the
floor. Bottom wall plates should sit
flush with outside of plywood floor.
When positioned correctly,fasten
bottom wall plates to floor using
4 -2 1/2” screws per wall panel.
Wall Plate
23.
Position angle cut
Rear Top Plates
on top of wall studs so they are flush on
the inside with 2x3 wall stud. The Top
Plate is comprised of 3 pieces (2 outside
pieces with an angle cut on one end and
a center piece that is straight cut). Attach
by screwing down into top wall plate with
4 -2” screws.
Angle cut on ends.
Top Plates should be flush
with inside of wall framing.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 11
32” wide
Confirm 32” Wide Door Opening at Bottom
Optional
- Caulking
seams will help
prevent moisture from
entering at seam.
Caulking not
included in kit.
Caulking
Floor
Angle
screws into perimeter
Floor Joists.