Outboards F2.5, Owner'S Manual

Page: 82 / 194

Maintenance
77
TIP:
The oil lubrication check window does not in-
dicate the engine oil level. Use the oil lubrica-
tion check window to make sure that the
engine is being lubricated with oil while it is
running.
6.
Insert the tube of the oil changer into the
oil filler hole, and then extract the engine
oil completely using the oil changer.
TIP:
When using an oil changer, skip steps 7 and
8.
7.
Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Remove the drain screw and gasket
while holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
TIP:
If the oil does not drain easily, change the tilt
angle or turn the outboard motor to port and
starboard to drain the oil.
8.
Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
TIP:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten the
drain screw to the correct torque with a
torque wrench as soon as possible.
9.
Add the correct amount of oil through the
filler hole.
NOTICE: Overfilling the oil
tank could cause leakage or damage.
If the oil level is above the upper mark,
extract oil until the oil is between the
upper and lower marks.
10. Install the oil filler cap and tighten it com-
pletely.
11. Leave the outboard motor for 5-10 min-
utes.
12. Remove the oil filler cap and wipe the at-
tached oil dipstick clean.
13. Install the oil filler cap and tighten it com-
pletely.
14. Remove the oil filler cap again and check
that the oil level on the dipstick is be-
tween the upper and lower marks. If the
1. Oil changer
1. Drain screw
2. Washer
1
1
2
Drain screw tightening torque:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
Recommended engine oil:
4-stroke outboard
motor oil
Engine oil quantity:
0.6 L (0.63 US qt, 0.53 Imp.qt)
U6BV74E0.book Page 77 Tuesday, December 10, 2013 1:10 PM