Outboards F2.5, Owner'S Manual

Page: 80 / 194

Maintenance
75
2. Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Loosen and remove the drain screw
and gasket while holding the container
under the drain hole. Then remove the oil
filler cap. Let the oil drain completely.
Wipe up any spilled oil immediately.
3. Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
TIP:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten the
drain screw to the correct torque with a
torque wrench as soon as possible.
4.
Add the correct amount of oil through the
filler hole. Install the filler cap.
NOTICE:
Overfilling the oil could cause leakage
or damage. If the oil level is above the
upper level mark, drain until the level
meets the specified capacity.
5. Turn off the engine and wait 3 minutes.
Recheck the oil level using the oil level
check window to be sure the level falls
between the upper and lower marks. Fill
with oil if it is below the lower mark, or
drain to the specified level if it is above
the upper mark.
1. Drain screw
2. Gasket
Drain screw tightening torque:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
2
1
Recommended engine oil:
4-stroke outboard
motor oil
0.35 L (0.37 US qt, 0.31 Imp.qt)
1. Oil filler cap
U6BV74E0.book Page 75 Tuesday, December 10, 2013 1:10 PM