Otto Bock Genium 3B1-2, Instructions For Use Manual

Page: 95 / 480

95
Status
LED Charging status
indicator (5 LEDs) Error Resolution
The LED
ring is lit
in weak
purple No LED is lit Distance between bat­
tery charger and
receiver of the char­
ging unit on the pros­
thesis too great. If the
distance is more than
2 mm, the prosthesis
cannot be charged. Reduce distance
between battery char­
ger and receiver of the
charging unit.
LED 2 and 4 are lit up Charger excess tem­
perature
LED 1, 3 and 5 are lit
up Excessively high or
low temperature of the
prosthesis
Check whether the
specified ambient con­
ditions for charging the
battery are met (see
Page 89). The LED
ring is lit
up yellow
LED 3 is lit up The prosthesis is not
being charged
Distance between bat­
tery charger and
receiver of the char­
ging unit too great. Connection may be
improved by reducing
the distance between
the charger and receiv­
er of the charging unit.
The LED
ring is lit
up green The battery charger is
functional but not con­
nected to the receiver,
or the distance
between the battery
charger and receiver
of the charging unit is
too great. Connect the battery
charger or reduce the
distance between the
charger and the receiv­
er of the charging unit
on the prosthesis.
The LED
ring is
flashing
red The prosthesis is not
being charged
Defective battery
charger. Reset the error by dis­
connecting and con­
necting the power sup­
ply.
If the error persists, the
battery charger and
power supply must be
inspected by an
authorised Ottobock
Service Center.
17.2.3 Error messages while establishing a connection with the cockpit app
Error message Cause Correction
Device not found
The connection could
not be established as no
component with the
entered serial number
could be found. Compare the serial number entered with
that of the component, then try to establish
the connection again.