Otto Bock Dino 3, Instructions For Use Manual

Page: 17 / 32

2) Set the desired foot plate angle (see fig. 14, item 2).
INFORMATION: Set the same angle on the left and right joint so that the foot plate is correctly posi­
tioned.
3) Tighten the clamping screw on the left and right joint of the foot plate to
10 Nm
(see fig. 14, item 1).
14
c) Adjusting the support angle of the following leg support:
• Single-panel for short lower leg length (aluminium)
1) Loosen the clamping screws on the left and right joint of the foot plate (see fig. 15, item 1; see fig. 16, item 1).
2) Set the desired foot plate angle (see fig. 16).
3) Tighten the clamping screws to
9 Nm
(see fig. 15, item 1; see fig. 16, item 1).
15 16
d) Adjusting the support angle of the following leg support:
• With single-panel foot plate for seating shell interface (steel)
1) Loosen the clamping screws on the left and right joint of the foot plate (see fig. 17, item 1).
2) Set the desired foot plate angle. Slide the clamping screws evenly in the left and right slotted hole without tilt­
ing.
3) Firmly tighten the clamping screws on the left and right joint of the foot plate (see fig. 17, item 1).
INFORMATION: Sufficiently tighten the clamping screws so that the foot plate remains securely posi­
tioned even when flipped up.
17 Dino 3
Settings