Otto Bock 3R80, Instructions For Use Manual, Page: 32 / 192

32
7.2 Bench alignment
►
CAUTION!
To enable the patient to stand safely, align the prosthesis using the alignment
images as well as the instructions for use of all prosthetic components being used. (
6
–
page: 5, 7 – page: 5)
Use 2Z11=KIT
INFORMATION:
The connection area of the prosthetic knee joint can be protected against
scratches with the protective film of the 2Z11=KIT during alignment in the workshop and testing
in the trial fitting area.
►
Use the protective film as illustrated in the accompanying document for the 2Z11=KIT.
► Remove the protective film before the patient leaves the fitting area.
Adapter inserts
►
Mount the adapter inserts shown in the illustration when using an alignment apparatus. (
8
–
page: 6)
→
: The prosthetic knee joint reference numbers shown in square brackets are marked on
the adapter inserts. The adapter insert reference numbers and mm dimensions in the
round brackets are not found on the adapter inserts.
Installing the tube adapter
CAUTION
Improper assembly of the screw connections
Risk of injury due to breakage or loosening of the screw connections
► Clean the threads before every installation.
►
Apply the specified torque values.
►
Follow the instructions for thread lock.
CAUTION
Incorrect processing of tube
Fall due to damage to the tube
►
Do not clamp the tube into a vice.
►
To shorten the tube, use only a tube cutter or a cutting device.
CAUTION
Incorrect mounting of the tube
Risk of injury due to breakage of load-bearing components
► Clean the contact surfaces of the tube and the tube adapter using a degreasing cleaning
agent.
►
Position the tube in the tube adapter so the minimum insertion depth is met.
►
CAUTION!
Position the tube adapter only in the permitted insertion range shown in the illus­
tration. ( 9 – page: 6)
→ : Permitted insertion range: 0 mm
→
: Impermissible insertion range: > 0 mm
7.3 Optimising the static alignment
INFORMATION:
Additional technical knowledge is provided by the instructions for use of the
measuring apparatus being used, the TF alignment poster and the Ottobock seminars.
The 743L500 3D L.A.S.A.R. Posture measuring apparatus is needed to optimise the static align­
ment.
The following optimisation methods are available:
•
: Optimisation with 3D mode activated
• : Optimisation with 3D mode deactivated