Otto Bock 3F1-1, Instructions For Use Manual

Page: 45 / 424

45
4. Are the ends of the actuator stirrup flush with the functional knee part?
Event Cause Correction
Noise development Incorrect position of the actu­
ator stirrup ends 1) Loosen a screw of the
actuator stirrup on the
functional knee part.
2) Reposition the actuator
stirrup (see fig. 12).
3) Tighten the screws of the
actuator stirrup.
4) Repeat steps 1-3 with the
second screw.
5. Is the position of the actuator stirrup correct?
Event Cause Correction
Collision between
actuator stirrup and
joint frame
Incorrect position of the actu­
ator stirrup 1) Remove the functional
knee part from the joint.
2) Position the actuator stir­
rup (see fig. 10).
3) Attach the functional knee
part to the joint.
6. Can the feedback signals be heard clearly enough?
Event Cause Correction
Feedback signals
cannot be heard
clearly enough Improper volume setting on
the joint
►
Adjust the volume of the
joint
feedback signals
(note the instructions for
use:
Genium
3B1-2/3B1-2=ST
"647G1148",
Genium
3B1-3/3B1-3=ST
"647G1380" and C-Leg
3C98-3/3C88-3
"647G1375").
6.10 Finishing the functional cosmesis
Complete the following steps to finish the functional cosmesis:
1) Assemble the functional shank, knee joint and prosthetic foot.
27
2) Fold over the coated ankle part of the func­
tional stocking (coating faces out).