Regulations for the prevention of accidents
GB
49
CPTX 400-2/400-2w/450-2w Synergy
1.6 Transport of the power source
The unit is generally suitable for transport.
The following requirements must be made to ensure an ease transport:
The device may only be lifted and transported with the provided handle.
Before lifting or transportation all connectors and cables have to be removed.
Never pull this device on the cables or plug.
1.7 Safety measures
Before using the machine, the following rules have to be observed:
Ensure the appropriate working conditions for the welder. At the work area no
inflammable substances may be presented. Reconciliation of dust and other
substances that prevent the isolation of the device must be removed.
Back up the welder properly when working outdoors.
If you notice any overheating or smoke, fire, find strange sounds and unusual
vibrations, you have to switch off the machine immediately and disconnect it from
power. In such cases the device has to be inspected by an expert.
In the event of a power outage, or when you realize power on the housing of the
device, switch off the machine immediately and disconnect it from power. The same
applies in the case of mechanical damage.
Too high humidity in the work area can reduce the insulation class and cause a short
circuit.
During welding some parts of the machine exceeds 100 °C. Therefore these parts are
protected with a thermostat. Whenever you will notice any overheating, you have to
turn off the power immediately.
Use environment:
The device is not suitable for bathrooms, showers, swimming pools or similar areas. If
it’s necessary to work in these environments, you have to ensure that water can’t
damage the machine
. The welding equipment isn’t suitable for use in rain or snow!
The w
elding equipment can’t be used in areas, where it is exposed to shock or
vibration. Areas that should be avoided necessarily are for example, road-, rail- and
cable handling equipment, aircraft, water crafts, cranes and parts of machine tools.
