Step 6. Preparing to Prime Machine
Important: This priming step must be
completed prior to first use.
•
Fill Water Reservoir
- Open the Lid and lift upwards using the
Handle inside.
- Fill with cold water from the tap.
- Insert the Water Reservoir into position &
close the Lid.
Note: Make sure that the Water Reservoir
is clean & free of any debris, as any fine
particles can block the water flow.
•
Power
- Ensure that the Steam & Hot Water DIAL is
in the vertical position.
- Insert the Power Plug into a 127V AC
power outlet & switch the power on.
- Press the ON/OFF BUTTON to turn on the
machine.
- The ON/OFF LIGHT will illuminate & pulse
to indicate the Thermoblock is heating up.
- The GRINDER LIGHT will be fully
illuminated from turn on.
- When the ON/OFF, EXTRACTION
BUTTONS & DIAL LIGHTS are all fully
illuminated, the machine is in the READY
state for EXTRACTION & DIAL features.
• Insert Group Handle
- Insert the Two Cup Filter Basket in the
Group Handle.
- Align the Group Handle with the 'INSERT'
position located on the left of the Group
Head.
- Insert the Group Handle flat against the
Group Head, then turn the Group Handle
right all the way to the centre position.
Note: Turning the Group Handle to the
centre position might be tight for the first few
uses.
Step 7. Prime Espresso Machine
- Press the TWO CUP BUTTON & water
should start flowing from the Group Head.
- Allow water to run through until it stops.
- The machine will return to the READY state.
Note: For the first few seconds the Pump will
make a louder than usual noise as it begins
pumping the water through.
- Position Steam Wand over the Drip Tray.
- Turn DIAL to HOT WATER.
- Allow water to run through for 20 sec.
- Return DIAL to vertical position.
- The machine will return to the READY state.
- Now the Espresso Machine should be
thoroughly primed.
- Wash Group Handle & Filter Basket in
warm water & dry before making your first
coffee.
- If water is not flowing from the Group Head,
repeat Step 7 one more time.
- If water is still not running through the
Group Head, contact Oster Customer Care.
Details are on the back page.
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
PLEASE EMPTY TRAY
MUEVA EL CAFÉ
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
MAX
2.8 L
1 L
MIN
MAX
2.8 L
1 L
MIN
TOP BURR
GRINDER
COLLAR
GRINDER
INTERLOCK
HOPPER
GUIDE
2.TURN
3.HOPPER GATES OPEN
1. ALIGN
& INSERT
COLADO
MANUAL
MOLINILLO
ENCENDIDO/
APAGADO
READY
3. CENTER
2.TURN
1. ALIGN
& INSERT
BEFORE FIRST USE OF THE ESPRESSO MACHINE
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
PLEASE EMPTY TRAY
MUEVA EL CAFÉ
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
MAX
2.8 L
1 L
MIN
MAX
2.8 L
1 L
MIN
TOP BURR
GRINDER
COLLAR
GRINDER
INTERLOCK
HOPPER
GUIDE
2.TURN
3.HOPPER GATES OPEN
1. ALIGN
& INSERT
COLADO
MANUAL
MOLINILLO
ENCENDIDO/
APAGADO
READY
3. CENTER
2.TURN
1. ALIGN
& INSERT
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
PLEASE EMPTY TRAY
MUEVA EL CAFÉ
BARISTA MAX
GRINDER
MANUAL SHOT
CLEAN
MAX
2.8 L
1 L
MIN
MAX
2.8 L
1 L
MIN
TOP BURR
GRINDER
COLLAR
GRINDER
INTERLOCK
HOPPER
GUIDE
2.TURN
3.HOPPER GATES OPEN
1. ALIGN
& INSERT
COLADO
MANUAL
MOLINILLO
ENCENDIDO/
APAGADO
READY
3. CENTER
2.TURN
1. ALIGN
& INSERT
English - 8
BVSTEM7300-054_19ESM4 (LA).indd 8
6/26/19 09:33