19
7. Water supply
> Lead the end of the Bowden cable through the front
cover into the holder inside the clean water tank.
The Bowden cable is secured by gently pushing it
into place and turning it clockwise. Turning it in the
opposite direction with release the cable.
> Cleaning product is applied to the floor as
required by pulling the white liquid lever. If the
lever is released, supply will stop immediately.
> If the motor is overloaded, the circuit breaker
(transparent cap with red button) will trip and
the power supply is stopped. The circuit breaker
is located above the power cable socket. After
approx. 30 seconds, the overload protection can
be switched on again by pressing the red button.
The machine is once again ready for operation when
the handle is placed back to its basic position.
8. Handling
Settings and preparations
1. Only use low foam, non-aggressive cleaning
products from Osmo: Wash & Care (interior use),
water (exterior use).
2. For the exterior: first apply Osmo Wood Reviver
Power-Gel with an Osmo Decking Brush or scrub
brush, and then run over the area with Osmo
Decking & Flooring Cleaning Machine.
3. Only use the appropriate brushes for the purpose
(see brush table and pressure settings).
4. Fill the black tank with cleaning product.
5. Plug in the machine.
6. Push the red button into the upper position.
