Oshkosh JLG 1500SJ, Service And Maintenance Manual

Page: 164 / 706

SECTION 3 - CHASSIS & TURNTABLE
3-114 – JLG Lift – 3121262
12. Lift the turntable into place on the bearing using the
previously installed guide pins for alignment.
13. Install all of the inner race bearing bolts hand tight.
Remove the guide pins to install the last two bolts. After
all of the bolts are installed, tighten them until snug. Dis-
connect the front lifting device at the front of the turnta-
ble (leaving the rear lifting device in place) to gain full
access to all bolts and torque the bolts according to the
torquing procedures in this section.
14. After all swing bearing bolts are torqued, the rear lifting
device can be disconnected.
15. Connect the hoses to the top of the swivel as tagged
during removal. Secure the hoses together with a tie
strap as shown.
16. Using an adequate lifting device, set the swing drive in
place on the turntable. Make sure the swing bearing
high spot is still aligned with the swing drive gear. If nec-
essary, swing the turntable slightly to align the mark
with the gear.