SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
31215932
3-13
Overload Indicator (LSS)
The Overload Indicator indicates when the
platform has been overloaded. An audible
alarm will also signal when the platform is
overloaded.
NOTE:
If the Overload Indicator is illuminated, further elevation will be
prevented. Reduce the weight in the platform to not exceed the
rated workload indicated on the capacity decal, then the con
-
trols will work again.
NOTE:
When ambient temperatures are below freezing, the LSS will
have a reduction in available capacity. This will trigger the LSS
before achieving the maximum allowable capacity.
Tilt Indicator Warning Light and Alarm
A red warning light on the control panel illumi
-
nates and an audible alarm sounds when the
chassis is at or beyond the tilt cutout settings.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTIVATED WHEN PLATFORM IS
RAISED, LOWER PLATFORM AND DRIVE TO A SMOOTH, FIRM SURFACE WITHIN THE
LIMITS OF THE MAXIMUM OPERATING SLOPE.
Variable Tilt - Platform Restricted Height
Indicator
This indicator shows the maximum allowable
platform elevation when the machine is within
the limits of the variable tilt envelope. When
activated, allowable platform height will be
shown in one of three height ranges, depending
on the amount of tilt detected by the machine’s
tilt sensor. See Table 2-2 for tilt angle - platform
operating height restrictions.
Horn
This push-button switch, when pressed, permits
the operator to warn job site personnel when
the machine is operating in the area.
Alarm
The alarm is mounted on the front of the plat
-
form control station and sounds for various
machine conditions or warnings such as a system-ready chirp or tilt
warning activation.
Summary of Contents for JLG R2632
