Oshkosh Corporation JLG 450AJ, Service And Maintenance Manual

Page: 184 / 342

SECTION 6 - JLG CONTROL SYSTEM
6-28 – JLG Lift – 3121659
STARTER LOCKOUT:
6*
1
2
DISABLED: Automatic pre-glow time determined by ambient air temperature; engine start
can be attempted at any time during pre-glow.
ENABLED: Automatic pre-glow time determined by ambient air temperature; engine start is NOT permitted until pre-
glow is finished.
1
* This menu item is visible only if Engine Selection ≠ Dual Fuel ECM
ENGINE SHUTDOWN:
7
1
2
DISABLED: No engine shutdown.
ENABLED: Shutdown engine for high coolant temperature fault or low oil pressure fault 2
FUEL CUTOUT:
8*
1
2
3
4
ONE RESTART: One restart with limited run time when near Empty.
ENGINE STOP: No starting permitted when near Empty.
NONE
RESTART: Restarts allowed with limited run time when near Empty 4
* Visible for Engine Selection = Kubota D1105 only
TILT:
9*
1
2
3
4
5
6
5 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than
5 degrees and above elevation; also reduces drive speed to creep.
4 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than 4 degrees and above
elevation; also reduces drive speed to creep.
3 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than 3 degrees and above
elevation; also reduces drive speed to creep.
5 D CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 5 degrees and
above elevation; also disallows tower lift up, drive, telescope out and lift up.
4 D CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 4 degrees and
above elevation; also disallows tower lift up, drive, telescope out and lift up.
3 D CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 3 degrees and
above elevation; also disallows tower lift up, drive, telescope out and lift up.
1
* Certain market selections will limit tilt options and alter default setting.
Note: Any of the selections above will light the tilt lamp when a tilted condition occurs and will sound the platform alarm when the machine is also above elevation.
JIB:
10*
1
2
NO: No jib installed.
YES: Jib installed which has up and down movements only. 2
* This menu item not visible.
Table 6-2. Machine Configuration Programming Information
Configurationn
Label/Digit
Number Description
Default
Number