Oshkosh Corporation JLG 450AJ, Service And Maintenance Manual

Page: 104 / 342

SECTION 4 - BOOM & PLATFORM
4-26 – JLG Lift – 3121659
10. Insert piston (3) in housing (1) until outer piston seal (12)
is touching inside housing bore.
11. Looking from angle shown, rotate piston (3) until marks
on piston and housing (1) line up as shown.
12. Using a rubber mallet, tap piston into housing to point
where gear teeth meet.
13. Look from opposite end of housing (1) to see if timing
marks line up. When they do, tap piston (3) in until gear
teeth mesh together. Tap piston into housing until it
bottoms out.
14. Install shaft (2) into piston (3). Do not damage seals. Do
not engage piston gear teeth yet.
15. Looking from view shown, use existing timing marks to
line up gear teeth on shaft (2) with gear teeth on inside