SECTION 3 - CHASSIS & SCISSOR ARMS
31215074
3-41
Rotary Angle Sensor Replacement
Removal:
1. Lower platform to the stowed position.
2. Disable the machine and disconnect the batteries.
3. Remove the screws securing the sensor cover to
the frame and remove the sensor cover.
4. Disconnect the wiring harness from old/existing
rotary angle sensor. Disconnect the sensor from
the arm pin and remove the sensor.
Installation:
1. Connect the wiring harness to the new rotary
angle sensor.
2. Position and connect rotary angle sensor to the
arm pin as shown below.
3. Rotate the sensor as described in the image above.
NOTE:
The sensor is spring loaded. DO NOT rotate past its
internal stops.
4. Install the rotary angle sensor cover and secure to
the frame with the two screws.
5. Reconnect the batteries.
3.13 GROUND CONTROL STATION
NOTE:
Anytime the ground control box is removed, the tilt
sensor must be re-calibrated. Refer to Section 5.3, Tilt
Sensor Calibration to re calibrate the tilt.
Box Disassembly
1. Disconnect the batteries.
2. Remove the three bolts at the bottom of the
ground control station.
3. Remove the four bolts where the control cable
enters into the control box.
4. Remove plug and place control box face down on
a suitable work bench.
Go to
Discount-Equipment.com
to
order your
parts
