![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-1930es/jlg-1930es_service-maintenance-manual_1655770051.webp)
SECTION 3 - CHASSIS & SCISSOR ARMS
31215074
3-9
Main Gearbox Disassembly
1. Using a screwdriver, pry off the cover snap ring.
2. Remove cover. Cover Thrust washer should be in
the inner counterbore of the cover.
NOTE:
To grip the cover for removal a pipe may need to be
inserted into the pipe plug holes.
3. Remove input sun gear.
4. Remove input carrier sub-assembly.
5. Remove cover o-ring.
6. Remove input ring gear.
NOTE:
The input ring gear is held in with a press fit on its
outside diameter. Insert jacking screws (1/4-20UNC
grade 8) with at least 1.5 inches of thread length into
each of the three tapped holes to force the ring gear
out. Be sure and alternate between the jacking
screws to keep the ring gear from becoming mis
-
aligned in the bore. The screws will push against the
outer race of the main bearing. This bearing will have
to be replaced afterwards.
7. Using a screwdriver remove spiral snap ring.
8. Pull hub sub-assembly off of the spindle sub-
assembly.
1. Spindle Sub-Assembly
2. Spiral Snap Ring
3. Input ring Gear
4. Input Sun Gear
5. Cover O-Ring
6. Cover Thrust Washer
7. Cover
8. Cover Snap Ring
9. Pipe Plug
10. Input Carrier Sub-Assembly
11. Hub Sub-Assembly
Figure 3-4. Main Gearbox Disassembly
Go
to
Discount-Equipment.com
to
order
your
parts