![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jerr-dan-hdr-70-85-530/jerr-dan-hdr-70-85-530_operation-and-maintenance-manual_1655760066.webp)
5-376-000094
REV. 3 - 03/10
Section II: Operation
Page 58
REAR HYDRAULIC STABILIZERS
Your HDR is equipped with rear hydraulic stabilizers. The stabilizers serve
two purposes. First, they may be used as a chassis support when lifting
heavy loads which would otherwise cause the front axle of the vehicle to lift
off the ground. Second, they can be used to provide a resistance to winching
forces. USE CAUTION AND GOOD JUDGEMENT!
Follow these simple steps:
1. Position the recovery vehicle as
close as possible to the work and
set the parking brakes and place
the transmission in neutral.
2. Engage the power take-off
(PTO). See PTO operator’s
instruction manual.
3. Adjust the electronic or manual
throttle control to elevate the
engine speed to approximately
1000-1200 R.P.M. of P.T.O.
output shaft speed for optimum
performance.
CAUTION:
Never exceed 1200 R.P.M.
When your hook up is complete,
reset the engine idle to normal.
Ea
st
ern
W
re
cke
r Sa
le
s
In
c