CAS40P 40 CFM / 100 PSIG
SECTION 7: TROUBLESHOOTING
PAGE - 59
®
An Oshkosh Corporation Company
7.1 GENERAL INFORMATION
This troubleshooting guide has been compiled from
operational and test data. It lists malfunctions/fault
conditions, possible causes, and suggested correc-
tive actions for the most common types of problems
that may occur. However,
DO NOT
assume that
these are the only problems that may occur. All avail-
able data concerning the trouble should be systemat-
ically analyzed before undertaking any repairs or
component replacement procedures. While it is
intended to be comprehensive, operators and main-
tainers can encounter malfunctions or problems not
listed in this table.
A detailed visual inspection is worth performing for
almost all problems, and may avoid unnecessary
additional damage to the machine. The procedures
which can be performed in the least amount of time
and with the least amount of removal or disassembly
of parts, should be performed first. Always remember
to:
1. Check for loose wiring.
2. Check for damaged piping.
3. Check for parts damaged by heat or an
electrical short circuit, usually noticeable by
discoloration or a burnt odor.
Should the problem persist after making the recom-
mended check, consult your nearest IMT representa-
tive or the Iowa Mold Tooling Co., Inc. Service
Department.
SECTION 7:
TROUBLESHOOTING
7.2 TROUBLESHOOTING GUIDE
MALFUNCTION/FAULT
POSSIBLE CAUSE
CORRECTIVE ACTION
Compressor will not start
PTO/hydraulics not engaged
Ensure hydraulics engaged.
Compressor switch OFF
Turn switch ON.
Continued on next page
IOWA MOLD TOOLING CO., INC.
500 Highway 18 West
Garner, Iowa 50438
Phone: 641.923.3711
Fax: 641.923.2424
www.imt.com
WARNING
Before performing maintenance:
Shut down machine, relieve all system
pressure and lock out all power, as per
the Safety Section of this manual. If
machine is hot, allow package to cool
before removing any panel.
NOTE THAT THE SYSTEM CAN BE
STARTED REMOTELY:
Always clearly tag the start-up
instrumentation against accidental
system start-ups during maintenance.
WARNING
DO NOT operate the compressor or any
of its systems if there is a known unsafe
condition. Disable the equipment by
disconnecting it from its power source.
Install a lock-out tag to identify the
equipment as inoperable to other
personnel.
Manual #99905382 Rev 02
(JUNE 2018)
Summary of Contents for IMT CAS40P
Page 119: ...BLANK PAGE...
