Oriental motor NETC01-M3, User Manual

Page: 4 / 62

Introduction
−4−
2 Introduction
„
Before use
Only qualified personnel should work with the product.
Use the product correctly after thoroughly reading the section "1 Safety precautions" on p.3.
The product described in this manual has been designed and manufactured for use in general industrial
equipment.
Do not use for any other purpose. For the power supply of the
NETC01-M3
, use a DC power supply with
reinforced insulation on its primary and secondary sides. Oriental Motor Co., Ltd. is not responsible for any
damage caused through failure to observe this warning.
„
Operating Manuals for the
NETC01-M3
Operating manuals for the NETC01-M3 are listed below.
After reading the following manuals, keep them in a convenient place so that you can reference them at
any time.
• Network converter MECHATROLINK-
Ⅲ
compatible NETC01-M3 USER MANUAL
This manual explains the function, installation and connection of the NETC01-M3 as well as operating
method.
The
USER MANUAL does not come with the product. For details, contact your nearest Oriental Motor
sales office or download from Oriental Motor Website Download Page.
For the command code or remote I/O of the RS-485 communication compatible product that can be
connected to the
NETC01-M3
, refer to the USER MANUAL of the corresponding RS-485 communication
compatible product or AZ Series Function Edition .
• Network converter MECHATROLINK-
Ⅲ
compatible NETC01-M3 OPERATING MANUAL
This manual explains safety precautions, connector pin assignments and others.
• Data setting software
MEXE02
OPERATING MANUAL
This manual explains the parameter setting method or monitor function using the
MEXE02
.
„
Overview of the product
The NETC01-M3 is a communication converter between MECHATROLINK-
Ⅲ
and RS-485 communication.
By converting the MECHATROLINK- Ⅲ communication protocol of the upper level to the RS-485
communication protocol of the lower level, Oriental Motor RS-485 communication compatible products can
be operated via MECHATROLINK-
Ⅲ communication.
The RS-485 communication protocol of the lower level is Oriental Motor's own RS-485 communication
protocol.
Parameters of the NETC01-M3 cannot be set with the master station.
When setting the parameters of the
NETC01-M3
, use a
MEXE02
or accessory
OPX-2A
.
When the
MEXE02
is used, a communication cable for data setting software
CC05IF-USB
(accessory) is
needed to connect a PC and NETC01-M3 . Be sure to purchase it.