OrCam User Guide
Version 7
Page
9
To attach the mount to the eyeglasses:
1.
Check the mount. On the inside, opposite the keyhole, is a small rubber
piece that you can feel with your finger. Occasionally, this piece may fall
out in the box. If you feel a hole instead of a bump, locate the missing
piece in the box and replace it.
2.
Insert the Allen key into the keyhole on the side of the mount and turn it
counterclockwise to open the mount to the widest position.
3.
With your eyeglasses right side up, push the mount loosely downward
onto the right side of the frame.
4.
Turn the eyeglasses upside down so you can see which size spacer is
required between the mount and the frame. Select the largest spacer that
allows the mount to slide onto the frame.
5.
Remove the mount from the eyeglasses and slide the selected spacer into
the mount in the direction of the arrow. If it doesn’t slide in, loosen the
mount slightly with Allen key.
6.
Push the mount downward onto the right side of the frame and slide it
almost as far forward as it can go. Be sure to leave a small amount of
space (one eighth of an inch) between the mount and the hinge, since
the camera housing takes up some space.
7.
With the Allen key, tighten the mount to fit snugly. Use the short end of
the key if necessary to complete the tightening process.
The mount is now attached to the eyeglasses and can be left there permanently.
The glasses may be folded with the mount in place.