7 Operation
Operating instructions RA 41 Plus (H)
22
(07.08)
MT_RA 41 Plus (H)_BA_04_790046773_04.doc
orbitalum tools
gmbh
7.5
Cutting the pipe (saw position 1 or 2)
Danger of being injured by chips flying around!
:
Never
work without the saw blade guard mounted.
X
Wear protective goggles.
Danger of being injured by sharp cutting edges or electric shock!
:
Keep hands away from the tools during cutting.
:
Never
equip both saw positions with saw blade/bevel cutter simultaneously
X
Wear safety gloves.
X
Disconnect the mains plug before mounting or dismounting, maintenance
or adjustment and allow the machine to run a stop.
If the pipe cutter has not been used for a long time:
–
Turn the motor by 180°.
–
Switch the motor on and let it run for approx. 10 s.
This will ensure that all gear components are lubricated.
1. Set the pipe dimension (see section 7.3.1, p. 18).
2. Mark the cutting point on the pipe.
3. Tighten the hexagon nut securing the saw blade (see section 7.1, p. 15).
4. Slide the pipe through the vice to the desired length and clamp tight.
5. Use the pipe support (Code 790 052 301) or the pipe feeder
(Code 790 068 001) for pipes that are more than 1m long.
6. Apply saw blade lubricant to the saw blade:
–
after every three cutting operations for pipes with outside diameters up
to 60 mm,
–
after each cutting operation for pipes with outside diameters more than
60 mm,
–
after every cutting operation for chrome-plated and alloyed steel pipes
WARNING
Important
Summary of Contents for RA 41 Plus
Page 39: ......
