7 Operation
Operating instructions RA 41 Plus (H)
20
(07.08)
MT_RA 41 Plus (H)_BA_04_790046773_04.doc
orbitalum tools
gmbh
1. Measure the outer diameter OD (mm) of the pipe to be cut.
2. Release the clamping lever (1).
3. Set the stop (2) to the outer diameter OD x s (lower scale).
4. Tighten the clamping lever (1).
7.3.4
"Simultaneous cutting and beveling of metal pipes
(s = 2 – 4.5 mm)" dimension setting (only at saw position 1)
Dimension setting only applies to Orbitalum Tools supplementary cutters for
the simultaneous beveling and cutting of metal pipes.
1. Place the pipe in the vice and slide it until it is just in front of the bevel
cutter, then tighten.
2. Release the clamping lever.
3. Using the grip, swivel the motor in a clockwise direction until the saw blade
projects approx. 1.5 mm into the pipe.
4. Tighten the clamping lever.
Setting ensures a minimum bevel height. If the bevel is too small, see
section 7.7.3, p. 29.
Note
Note
Summary of Contents for RA 41 Plus
Page 39: ......
