Operating instructions RA 41 Plus (H)
7 Operation
orbitalum tools
gmbh
(07.08)
MT_RA 41 Plus (H)_BA_04_790046773_04.doc
27
7.7
Simultaneous cutting and beveling
(only at saw position 1)
At saw position 1 pipes with wall thickness up to 4.5 mm can be cut and
beveled at the same time.
If supplementary cutter is used, turn the motor around the pipe more slowly
than you would during a normal cutting operation as two tools are being used
at the same time.
Danger of being injured by chips flying around!
:
Never
work without the saw blade guard mounted.
X
Wear protective goggles.
Danger of being injured by sharp cutting edges or electric shock!
:
Keep hands away from the tools during sawing/beveling.
:
Never
equip both saw positions with saw blade/bevel cutter simultaneously
X
Wear safety gloves.
X
Disconnect the mains plug before mounting or dismounting, maintenance
or adjustment and allow the machine to run a stop.
1. Connect the RA 41 Plus (H) to the mains.
2. Apply saw blade lubricant to the teeth of the saw blade and cutting surfaces.
Relubricate after every cutting operation. Use Orbitalum Tools lubricating gel
only for pipes which come into contact with drinking water or foodstuffs.
7.7.1
Simultaneous cutting and beveling of thin-walled pipes
(s = 1 – 2 mm)
1. Set the pipe dimension as described in section 7.3.3, p. 19.
2. Mark the cutting point on the pipe.
3. Insert the pipe into the vice.
4. Slide the marked cutting point over the saw blade.
5. Clamp the pipe in the vice.
6. Use the pipe support (Code 790 052 301) or the pipe feeder
(Code 790 068 001) for pipes that are more than 1 m long.
Important
WARNING
Important
Summary of Contents for RA 41 Plus
Page 39: ......
