Orban OPTIMOD-FM 5518, Operating Manual

Page: 80 / 217

2-42
INSTALLATION ORBAN MODEL 5518
Use this function to periodically re-sync the 5518’s internal clock to your station’s
master clock.

Reset Clock to Midnight : Resets the clock to 0:00:00. You can use this function
to periodically re-sync the 5518’s internal clock to your station’s master clock.

No Function : remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape button to return to higher menu levels.
Networking and Remote Control
[Skip this step if you do not wish to connect to your 5518 remotely, either for
downloading software upgrades or for PC Remote Control.]
The 5518 has a built-in Ethernet connector that can be used with 10 Mbps or 100
Mbps ports using the TCP/IP protocol. You can also connect a PC to the 5518 through
the 5518’s RS-232 serial port, either by modem or directly through a null modem ca-
ble.
1. Prepare the 5518 for an Ethernet network connection:
[Skip this step if you will not be using an Ethernet connection.]

See your network administrator to get the data required in the following
procedure.

Note that if you wish to do this from the 5518 PC Remote software, then you
must first be able to connect to the 5518. Therefore, you will usually perform
this procedure from the 5518’s front panel to prepare it for connection.
A) Navigate to
Setup > N
ETWORK
& R
EMOTE
> Next
.
B) Press the
S
ET
IP A
DDRESS soft button.
The IP Address Screen appears.
a) Use the
Next
and
Prev
keys to move the cursor in turn to each digit in the IP
address. Use the knob to set the digit to the desired value. Repeat until you
have selected all the numbers in the IP address assigned by your network
administrator
b) Press the
S
AVE
soft button to confirm your setting.
C) Set the Subnet Mask assigned by your network administrator if necessary:
a) Press the
S
ET
S
UBNET
M
ASK soft button.