Orban OPTIMOD-FM 5518, Operating Manual

Page: 122 / 217

2-84
INSTALLATION ORBAN MODEL 5518
SNMP Support
The SNMP (Simple Network Management Protocol) features allow you to monitor
your Optimod’s status and to send Alarm notifications via your Optimod’s Ethernet
connection to your network. It is beyond the scope of this manual to provide a gen-
eral explanation of how SNMP works. The text below provides sufficient information
to use your Optimod in your specific SNMP setup if you are already familiar with the
general principles of setting up SNMP.
SNMP Network Setup

SNMP (Enable/Disable): enables or disables the SNMP feature. Select “enable”
and disconnect from the PC remote to update the unit and allow SNMP access.
If you wish to disable SNMP access after it has been enabled, select “dis-
able” and then reboot your Optimod.
F) From the main menu, navigate to
Setup > N
ETWORK
&R
EMOTE
> N
ETWORK
>
SNMP E
NABLE
.
If the
SNMP E
NABLE
soft button is not visible, press the
Next/Prev
but-
tons until it is.
G) While holding down the
SNMP E
NABLE soft button, turn the knob to set the
SNMP E
NABLE field to
Y
ES .
The controls below are only available from Optimod PC Remote.
In the I/O menu, select the
N
ETWORK tab to access the SNMP configuration controls.

Primary Manager Address : (255.255.255.255) sets the address of the Primary
SNMP Manager.

Primary Manager Port : (162) sets the port of the Primary SNMP Manager.

Secondary Manger Address : (255.255.255.255) sets the address of a Secondary
SNMP Manager.

Secondary Manger Port : (162) sets the address of a Secondary SNMP Port.
SNMP Mib file
The orban5500.mib file is in the location where you installed your PC Remote appli-
cation.
The default 5518 install location is: