Orban OPTIMOD-FM 5518, Operating Manual

Page: 59 / 217

5518-FM DIGITAL INSTALLATION
2-21
28. Program Tally Outputs.
[Skip this step if you do not wish to use the tally outputs.]
See step 6 on page 2-4 for wiring instructions.
You can program the two tally outputs to indicate a number of different opera-
tional and fault conditions.
A) Navigate to
Setup > N
ETWORK
R
EMOTE
> R
EMOTE
I
NTERFACE
> T
ALLY
1
.
B) Program tally output #1.
To program a given tally output, press and hold the soft button associ-
ated with the output you are programming. As you turn the control
knob, the functions listed below will appear in the highlighted field.

Input: Analog : Indicates that the 5518 is processing audio from its analog
input.

Input: Digital : Indicates that the 5518 is processing audio from its AES3
digital input.

Analog Input Silent : Indicates that the level at either or both analog in-
put channels is below the threshold set in step 26 on page 2-20.

AES Input Silent : Indicates that the level at either or both digital input
channels is below the threshold set in step 26 on page 2-20.
Currently, this feature applies only to the stand-alone stereo encoder
mode.

AES Input Error : Indicates that the 5518’s AES input receiver chip has de-
tected a problem with the data being received such that the data is unus-
able. When the chip detects such an error, it automatically switches the in-
put to
A
NALOG
.

Sync Reference Input Error : Indicates that the 5518 has detected a prob-
lem with the signal being received at the sync reference input such that the
signal is unusable.
o
When pilot sync is specified (
S
ETUP
> I/O C
ALIB
> D
IG
O
UT
C
ALIB
> DO
S
YNC ) and such an error is detected, the 5518 automatically switches
the sync source to the digital input.
o
If there is no valid digital input signal at the digital input, the sync
source defaults to the 5518’s internal clock.

No Function : Tally output is disabled.
C) Program tally output #2 if you wish, following the procedure in step (B) above
with the
T
ALLY
O
UT
2
button.