Orban OPTIMOD 6200, Operating Manual

Page: 44 / 195

2-2
INSTALLATION ORBAN Model 6200
Installing the 6200
Allow about 2 hours for installation.
Installation consists of: (1) unpacking and inspecting the 6200, (2) optional resetting of
jumpers for input termination, (3) checking the line voltage setting, fuse, and power
cord, (4) mounting the 6200 in a rack, (5) connecting inputs, outputs and power, (6) set-
ting the Ground Lift switch, (7) optional connecting of remote control leads — 6200
OPTIMOD-DAB only — and (8) optional connecting of computer interface control
leads.
When you have finished installing the 6200, proceed to “System Setup,” on page 2-23.
DO NOT connect power to the unit yet!
1. Unpack and inspect.
A)
If you note obvious physical damage, contact the carrier immediately to make a
damage claim. Packed with the 6200 are:
1 Operating Manual
1 Line Cord
2 Fuses (F1 = ½A or 250mA
depending upon specified mains voltage)
4 Rack-mounting screws, 10-32 x ½ — with washers, #10
B)
Save all packing materials! If you should ever have to ship the 6200 (e.g., for ser-
vicing), it is best to ship it in the original carton with its packing materials because
both the carton and packing material have been carefully designed to protect the
unit.
C) Complete the Registration Card and return it to Orban. (please)
The Registration Card enables us to inform you of new applications, per-
formance improvements, software updates, and service aids that may be de-
veloped, and it helps us respond promptly to claims under warranty without
our having to request a copy of your bill of sale or other proof of purchase.
Please fill in the Registration Card and send it to us today. (The Registration
Card is located after the cover page).
We do not sell our customer’s names to anyone.
2. Change standard factory input termination, if required.
[Skip this step if your installation does not require 600
Ω
termination on the
analog left/right inputs.]
The analog left/right inputs are shipped from the factory with balanced bridg-
ing (10k
Ω
) input impedance. However, the 6200 analog inputs can be changed
to 600
Ω
input impedance.
To change the input impedance of the analog left/right inputs: