Oracle Sun Server X4-4, Installation Manual

Page: 62 / 148

Modify Network Settings From the Oracle ILOM Web Interface
a.
Specify the property types. For example:
->
set state=enabled
->
set pending_static_ipaddress=fec0:a:8:b7:214:4fff:feca:5f7e/64
Property Value to Set Description
state enabled
or
disabled
The IPv6 network state is enabled by default. To
enable a static IP address this state must be set to
enabled.
pending_static_ipaddress
<ipv6_address>/
<subnet_mask_length_in_bits>
Type this command followed by the property value for
the static IPv6 address and netmask that you want to
assign to the device. IPv6 address example:
fec0:a:8:
b7:214:4fff:feca:5f7e/64
b. Commit the pending IPv6 static network parameters by typing the following
command:
->
set /SP/network commitpending=true
Note -
Network settings are considered pending until you commit them. Assigning a new static
IP address to the server will end all active Oracle ILOM sessions to the server. To log back in to
Oracle ILOM, you will need to create a new session using the newly assigned IP address.
9. Test the IPv4 or IPv6 network configuration from Oracle ILOM using the Network
Test Tools (Ping and Ping6).
For details, see “Test IPv4 or IPv6 Network Configuration From the Oracle ILOM
CLI” on page 64 .
Modify Network Settings From the Oracle ILOM
Web Interface
If you want to modify the network settings currently configured for the server from the Oracle
ILOM web interface, use the following procedure.
Note - You can also change network settings using the BIOS Setup Utility. For instructions,
refer to “Access the BIOS Setup Utility” in Sun Server X4-4 Service Manual .
1. Log in to the Oracle ILOM web interface using the relevant steps in “Log In to
Oracle ILOM Using a Remote Ethernet Connection” on page 56 .
62 Sun Server X4-4 Installation Guide • October 2015