Oracle Sun Server X4-4, Installation Manual

Page: 59 / 148

Modify Network Settings From the Oracle ILOM CLI
Modify Network Settings From the Oracle ILOM
CLI
If you want to modify the network settings currently configured for the server from the Oracle
ILOM CLI, use the following procedure.
Note - You can also change network settings using the BIOS Setup Utility. For instructions,
refer to “Access the BIOS Setup Utility” in Sun Server X4-4 Service Manual .
1. Log in to the Oracle ILOM CLI using the relevant method in “Log In to Oracle
ILOM Using a Local Serial Connection” on page 55 or “Log In to Oracle ILOM
Using a Remote Ethernet Connection” on page 56 .
2. Perform the network configuration instructions that apply to your network
environment, then test the network settings:
■ To view or configure IPv4 network settings, perform Step 3 and Step 4.
■
To view or configure IPv6 network settings, perform Steps 5 through 8.
3. For IPv4 network configurations, use the
cd
command to navigate to the
/SP/
network
directory:
->
cd /SP/network
4. Do one of the following:
■
If you have a DHCP server on the network, type the following command to
view the settings assigned to the server by the DHCP server:
->
show
■ If there is no DHCP server, or if you want to assign settings, use the
set
command to assign values for the properties listed in the following table.
For example:
->
set pendingipdiscovery=static
->
set pendingipaddress=10.8.183.106
->
set pendingipnetmask=255.255.255.0
->
set pendingipgateway=10.8.183.254
->
set commitpending=true
Connecting to Oracle ILOM 59