Installing the Hardware
Installing the Hardware
Follow the procedures in this section to install the hardware:
■
“To Install the Converged Network Adapter” on page 20
■
“To Connect an Optical Cable” on page 23
■
“To Connect a Copper Cable” on page 24
■
To Install the Converged Network Adapter
1.
If the system in which you are installing the adapter is running the Oracle Solaris
OS, install the two driver patches for your platform, as listed in
System and Technology Requirements” on page 11
.
2.
Attach an ESD wrist strap (see
3.
Refer to your system installation or service manual to determine an appropriate
PCI Express slot in which to install the Converged Network Adapter.
4.
Refer to your system documentation to shut down, power off, and unplug the
system, if necessary.
5.
If you do not want to replace the PCI bracket, skip to step 6. Otherwise, if you
want to replace the PCI bracket, perform these steps:
Note -
The Converged Network Adapter comes with a low-profile PCI bracket installed.
This bracket is approximately 3.11 in. (7.9 cm) long. A standard mounting bracket, which is
approximately 4.75 in. (12.6 cm), is provided with each order.
a.
Remove the SFP(s), if installed.
Caution -
Do not replace any of the SFP+s. Doing so will void the warranty or serviceability of
the Converged Network Adapter.
20
Sun Storage 10 GbE FCoE PCIe Converged Network Adapter From QLogic Installation Guide For Adapter Models
SG-PCIEFCOE2-Q-SR, SG-XPCIEFCOE2-Q-SR, SG-PCIEFCOE2-Q-TA, SG-XPCIEFCOE2-Q-TA, 7105381, and
7105382 • March 2017
Summary of Contents for 7105381
Page 2: ......