M4RTU/M4 I/O User’s Guide
45
INSTALLATION AND SETUP
INSTALLING I/O MODULES
Caution:
TURN OFF POWER to the M4RTU/M4 I/O before installing or removing I/O modules.
The M4RTU/M4 I/O board, located at the top of the unit just below the top cover, accommodates eight digital
and four analog G4 input/output modules. The placement for these modules is shown below.
To install I/O modules, you do not need to remove the top cover, unless you will be changing field wiring at the
same time.
Install each digital or analog module as follows:
1.
Choose the appropriate channel location on the M4RTU/M4 I/O board and carefully line up the I/O
module pins with the sockets on the I/O board.
2.
Press the module firmly into place until it seats all the way down on the I/O board.
3.
Use a Phillips screwdriver to tighten the screw that will secure the I/O module.
Figure 3-12: Placement of Digital and Analog Modules
Summary of Contents for Modular M4RTU
