M4RTU/M4 I/O User’s Guide
37
INSTALLATION AND SETUP
Use the
Configure Controllers
-
Setup Controller Ports
dialog box in OptoControl to set the baud rate for any
M4RTU/M4 I/O serial port that is not being used as the primary host port. Consult the
OptoControl User’s Guide
for more information.
Address Jumpers (ADDRESS 0–7)
Use these jumpers to select an 8-bit address from one to 255 (one to FF hexadecimal). The factory default is one
(jumper zero in, all others out). The most significant bit is seven and the least significant bit is zero; address zero
is reserved and should not used. Refer to Figure 3-6.
Processor Board Jumpers
Four additional jumpers are located on the main processor board, as shown below. For details on accessing
these jumpers, see Appendix E (Upgrading RAM and Flash EEPROM).
Table 3-3 describes the use and default settings of all jumpers. When a jumper is installed, the setting
corresponding to the “In” position is in effect. When a jumper is not installed, the setting corresponding to the
“Out” position is in effect.
Each jumper is described in detail on the following pages.
Figure 3-6: Address Jumper Setting
Summary of Contents for Modular M4RTU
