40
M4RTU/M4 I/O User’s Guide
INSTALLATION AND SETUP
INSTALLING EXPANSION CARDS
If you purchased expansion cards, you will need to install them in the M4RTU/M4 I/O before mounting the base
unit.
The general procedure for installing optional cards is as follows:
1.
If installed, remove the power connector from M4RTU/M4 I/O power supply.
2.
Remove the end cap for any of the three expansion slots, located below the M4RTU/M4 I/O base unit
serial connectors. Each end cap is held in place by two screws located on the side panel, adjacent to
each end cap. (You may also need to remove one or two additional end caps to achieve proper card
alignment.)
3.
Align the edges of the card with the U-channels on the sides of the expansion bus cavity. Slide the card
all the way in until it seats into the M4RTU/M4 I/O bus connector.
4.
Use the original screws to attach the new end cap (included with the card) to the end of the M4RTU/
M4 I/O unit.
See Figure 3-8 for reference. For complete details on installing the M4SSER, see M4 Serial Adapter Card Data
Sheet (form 664). For details on installing expansion cards, see the appropriate expansion card data sheet.
The form numbers can be found in Chapter 2, page 23 of this manual.
Figure 3-8: Installing an Expansion Card into the M4RTU/M4 I/O Expansion Slot
Summary of Contents for Modular M4RTU
