CHAPTER 2: GETTING STARTED
groov
Box User’s Guide for GROOV AT1
9
9
Step 2: Choose a Location
Locate a suitable wall or panel near a standard 120VAC or 240VAC wall outlet and the wired Ethernet
network(s) your computer is on. If your controller, Modbus/TCP device, or OPC UA server is on a
different network than your computer, connect ETH0 to your computer's network and ETH1 to the
other network. (Also see
Allow room around the front, top, and sides of the
groov
Box. Air needs to flow freely though the
fans on the sides, and you need to be able to see the information on the top.
Step 3: Mount the
groov
Box
You can mount the
groov
Box on a flat surface using the four mounting tabs, or you can mount it on
a DIN rail using the DIN rail clips provided on the back of the
groov
Box. Use #8 screws with the
mounting tabs. If there will be vibration at the
groov
Box installation site, make sure to use the
mounting tabs for a secure installation.
Step 4: Connect to the Network
Method 1:
Mount to a flat surface
using the mounting tabs
Method 2:
Mount to a DIN rail
ETH0 to computer network
ETH1 to control network
(if on a separate subnet)
Summary of Contents for GROOV BOX
