CHAPTER 3: USING GROOV ADMIN
groov
Box User’s Guide
27
27
6.
Enter the Network Key.
Use the key for the Encryption Type selected above. This is a write-only field.
7.
Scroll down to the Boot Time Interface Parameters section.
8.
Select From DHCP.
If the wireless network does not have a DHCP server, assign a static IP address and netmask.
9.
Click Save.
Wait till you see the following message.
Congratulations. You’re connected!
10.
If ETH0 and WLAN are on the same subnet, disconnect the cable from ETH0.
You need to disable ETH0 because the
groov
Box will continue to communicate over ETH0 as
long as it is connected on the same subnet and enabled.
NOTE: If you are using a control network and an enterprise network, and ETH0 is on a different subnet,
you can leave it connected.
a.
In the Network Configuration page, click ETH0.
Summary of Contents for GROOV BOX
