User Manual – eSX
OptiPro Systems, LLC.
Page 36 of 111
Last Modified: 8/27/2014
c.
After
MOTION STOP
is pressed tap [ENABLE JOG] in the Function Bar to enable axis jogging
functionality within Automatic Mode; jog the machine as needed.
Use extreme caution when
manually jogging the axes to prevent a collision. See Sections 5.1, 5.2, and 7.3 for additional
information regarding manual jogging.
From here do one of the following:
i.
Press
E-STOP
to stop all axes, spindles, and coolant flow; work holding vacuum will
remain active.
ii.
Continue the cycle by pressing the
CYCLE START
button.
iii.
Stop the spindles and immediately terminate the program by pressing
RESET
.
d.
Press
RESET
on the Jog Panel (Figure 5-6) to stop the spindles and immediately terminate the
program.
7.4.2
G-Code Viewer
Tap [VIEW GCODE] to open a window that will display the G-Code for the active program (used for
program verification and/or trouble shooting). This window can be accessed and exited while the
program is running without effecting operation.
7.4.3
Loading External Programs
The machine can execute programs that are generated offline (not with the G-Series software). These
files are usually manually typed out or generated with a CAD/CAM application.
CAUTION: G-Series software has built in safety features may not be available when using external
programs. Only operators who are trained and qualified to write and execute machine tool code, well
versed in CNC machine setup, programming, and operating, and well trained and experienced on this
machine should attempt to run programs not generated within the G-Series software.
1.
Access the Offset Tables from the G-Series Submenu (Section 7.2).
NEVER MODIFY OR UNLOCK G54 OR G55 VALUES EXCEPT FOR TRAMMING IN THE G-SERIES SOFTWARE.
2.
G56, G57, and G58 Offset can be used for external programs, adjust these values as required for
the application.
3.
Enter AUTO MODE from the G-Series Submenu (Section 7.2).
4.
Tap [LOAD PROG] in the Navigation/Function Bar, browse for and open the desired file.
NEVER RUN A PROGRAM FROM A USB DRIVE OR OTHER REMOVABLE STORAGE
5.
Press
CYCLE START
to begin the program
In Emergencies: Press the
E-STOP
button
on the Jog Panel (Figure 5-9) in any situation in which the
operator feels it is warranted to immediately halt axis motion. See Section 6.3 for more information
regarding E-Stop.
