User Manual – eSX
OptiPro Systems, LLC.
Page 10 of 111
Last Modified: 8/27/2014
4.4
In An Emergency
The emergency stop button is located on the operator control panel. When the emergency stop button
is pressed all machine motion and spindle motion is shut down. The controller, however, remains active
and the software functions may be used. Once the reason for the Emergency Stop has been determined
and corrected, normal operations may resume by turning the
EMERGENCY STOP
button clockwise until
it releases from its locked position. The
RESET
button must then be pressed to clear the error bar (found
in the top right corner of the display).
IN AN EMERGENCY SITUATION:
Press the
EMERGENCY STOP
button.
In the case of serious injury, fire, or other hazardous conditions,
IMMEDIATELY CONTACT
YOUR LOCAL EMERGENCY RESPONSE PROFESSIONALS.
If necessary, switch off the main power disconnect on the rear of the machine and the main
air supply at the utility control panel. It is preferred to follow the instructions in Section 6 to
properly shut down the machine.
Follow your company’s procedures and policies for emergency reporting, response,
resolution, and documentation.
Once the cause of the emergency has been resolved the procedure for restarting the
machine can be found in Section 6 of this manual.
