Optimum HZ-1014, Operating Instructions Manual

Page: 9 / 34

9
INSTRUCTION MANUAL
FOOT MASSAGER HZ-1014
INTRODUCTION:
Proper use produces a measurable increase in blood circulation
in the skin of the feet which manifests itself in a pleasant and
lasting feeling of warmth (rise in skin temperature). Foot
massager baths at regular intervals can produce improved
blood circulation in the feet and indirectly in the entire leg area
as well.
Temperature-controlled full-length heaters under each of
foot rests maintain the desired temperature throughout your
massager when you set the rotary switch of the unit.
There are about 400 stimu-nodes act as gentle fingers to make
contact with the soles of your feet and give you most effective
and invigorating massage possible. You can easily control their
effectiveness by simply pressing down lightly or letting up
the pressure with your feet. There are 70 air jets provide a
relaxation warm bubble bath for your feet.
READ INSTRUCTIONS BEFORE USING:
When using electrical appliances, especially when children are
present, basic safety precautions should always be followed as
below:
1. DO NOT attempt to plug in and unplug the unit while feet
are in water.
2. Before plugging in or unplugging the unit, be sure the
rotary switch is in OFF or “0” position.
3. NEVER immerse the unit completely into water or other
liquid for cleaning or other purposes.
4. DO NOT stand up or placing other objects in the unit, use
it only when you are in sitting position.
5. DO NOT leave the unit in ON position when the unit are
not in use or ready for use.
6. DO NOT operate the unit if it has a damaged cord or plug. .
If it is not working properly, or has been dropped or
damaged in any way whatsoever. Take it to the nearest
service centre for examination and repair, or for mechanical
adjustment.
7. DO NOT pull the unit by the cord, or use as a handle.
8. CLOSE SUPERVISION is necessary when the unit is used
by, or near children, or invalid.
9. DO NOT use while sleeping, or if you feel drowsy.
10 USE ONLY on a flat level surface in indoors, never use
outdoors.
11. Discontinue use if you feel discomfort, or if any pain or
irritation results, never use for swollen or inflamed feet,
or if feet have any skin eruptions. First, consult your
physician.
12. The appliance has a hot surface. Persons insensitive to heat
must be careful when using the appliance.
13. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
14. This appliance is not intended for use by children or other
persons without assistance or supervision if their physical,
sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure that they do
not play with the appliance.
This appliance may be plugged into AC electrical outlet.
(Ordinary household current) Do not use any other outlets.
CARE AND MAINTENANCE:
This appliance is for household use purpose, there is no user
serviceable parts inside. Do not try to open or change the parts
by yourself. Please refer to qualified electrical service or return
to the nearest services centre if servicing is needed. This is a
health care unit, not a washing basin. Clean feet before use
and use clean and soft water.
Deposit will clog air jets and
undermine the bubble effect.
TO CLEAN: After using, simply rinse out with water. Never
immerse the entire unit into water. If you wish, you can wipe
off all surfaces with a cloth damped with water and a mild
detergent, then rinse and dry.
TO STORE: Be sure the unit are unplugged, cooled and
emptied of water. Then store it in a clean and dry place. Before
storage just to wore the whole power cord round the wiring
holder. Never hang the unit by the power cord.
HOW TO USE THE MASSAGER:
The appliance must be operated with water.
To check the rotary switch is in OFF or “0” position. Then plug
the power cord into AC outlet (regular household current).
DO NOT CONNECT OR DISCONNECT THE PLUG
FROM THE POWER OUTLET WHILE YOUR FEET
ARE IN THE WATER.
Seat yourself comfortably, place feet on the foot rests and
select your desired setting for heat only, massage only, or heat
and massage.
USING THE CONTROL SWITCH YOU CAN SELECT
THE DESIRED APPLICATION:
OFF (0)
Turn the unit off.
M INFRARED [B + M + IR] (1)
Set switch to this mark if you want to massage your feet in
bubble cold water bath. A foot vibration massage with infrared
is also possible with this setting.
UK
HZ1014_IM_207.indd 9 2011-01-1...15:09:34