OPTIMUM
M A S C H I N E N - G E R M A N Y
The front panel and rear panel
15 / 06 / 2011
Page 13
The front panel and rear panel Digital position display DPA 2000/ DPA 2000S ; Version 2.1.2
©
201
1
GB
2.4
Measuring device - Pin Assignment at DPA 2000
The functional designation of the wires, that each pin at the 9-Pin-SubD-plug is allocated, must
have the same assignment as the connector at the digital display.
The assignment is shown in the following tables.
INFORMATION
The DPA 2000 is designated for the operation with measuring devices, that provides a
Sine 1Vpp output signal (= voltage between the upper and lower peak of the wave is 1 Volt).
NFORMATION
We are recommending the application of original OPTIMUM measuring gibs, because this will
ensure a quick and failure-free operation.
If it is indented to operate the digital display with measuring devices from other manufacturers,
pay attention that this measuring gib is providing an output signal from the type „Sine 1Vpp“ and
the pin assignment is consistent to the following table.
2.5
Measuring device - Pin Assignment at DPA 2000S
INFORMATION
The DPA 2000S is designated for the operation with measuring devices, that provides a
Sine 1Vpp output signal or a TTL square wave output signal.
NFORMATION
We are recommending the application of original measuring gibs and magnetic measuring sys-
tems from OPTIMUM, because this will ensure a quick and failure-free operation.
If it is indented to operate the digital display with measuring devices from other manufacturers,
pay attention that this measuring gib is providing one of the supported output signal types and
the pin assignment is consistent to the following table.
PIN No.
1
2
3
4
5
6
7
8
9
sine 1Vpp signal
for OPTIMUM mea-
suring gibs ML
0°
180°
+5V
0V
90°
270°
Z
Blank
Shielding
