Maintenance
Version 1.0 dated 2019-01-31
Page 16
Translation of the original instructions
V 99 S
│
V 250 S
GB
V99_
V250
_4_G
B.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
4
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the automatic table feed.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long service life of the automatic universal table feed and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
4.1
Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions.
When properly used, the automatic table feed is largely maintenance free.
4.2
Repair
If the repairs are carried out by qualified technical personnel, they must follow the indications
given in these mounting instruction.
4.3
Troubleshooting
weekly
or
as required
V99S/ V250S
Lu
bri
c
a
te
Check that the gears are lubricated with grease.
Lubricate the gears with a standard grease.
Failures
Failure causes
Troubleshooting
V99S/ V250S
does not work
1. Make sure that the power
cable is well connected.
2. Make sure that the power
switch is on.
3. Make sure that the voltage is
suitable.
1. Make sure that the power cable is well con-
nected. Then switch on the power supply.
2. Switch on the power switch.
3. The voltage should be 230V +/ - 10 %.
